![]() ![]() Simple Network Management Protocol (SNMP) is a set Teo frustatuschange and cpStatuschange traps are enabled. > snmpconfig -enable mibcapability -min_name HA-MIB -trap_name cpStatusChange > snmpconfig -enable mibcapability -mib_name HA-MIB -trap_name fruStatusChange > snmpconfig -set mibcapability -min_name HA=MIN -bitmask 1 Just to enable, you don't have to run into interactive mode, only thing you need is MIB name and trap name > snmptraps -send -trap_name cp-status-change-trap -ip_address 192.168.10.120 Since we already know the snmp server information, lets test it if snmp forwards the traps. To change the MIB capability, you the snmpconfig command View currently enabled trap on your switch. it is a database of monitored and managed information on a device. Get the IP address and the severity level. You have to pay attention to SNMP Trap recipient information. ![]() The setting command is interactive which mean, you will enter the value at the prompt. When an event occers and its severity level is equal to or below the set value, the snmp event traps are forwarded to the trap recipients, that is snmp servers. Snmpconfig command allow you to managge snmpv1/v3 agent configuration on SAN switch.Įvent trap level is mapped with event severity level.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |